Designer Version 3.1

Release Date: 1/15/2019

Important

When upgrading from Designer 3.0 to Designer 3.1, the installer will prompt that the destination folder C:\Program Files\Shure\Shure\Shure Designer is not empty; please change the Shure Designer folder name (e.g. Shure Designer 3.1) or delete the existing Shure Designer folder and it will automatically be re-created during the upgrade.

Improvements

• Support for both virtual and discovered devices
• Support for new products:
  • P300 IntelliMix® Audio Conferencing Processor
  • ANIUSB-MATRIX USB Audio Network Interface
  • MXA310 Table Array Microphone
• Routing for supported devices
• Reusable location templates
• Location security settings
• Bug fixes

Known Issues

• When using Windows 7, no more than five windows can be open simultaneously.
• Templates that were created from a location will be empty when the project is exported and then imported. This does not affect locations that weren’t copied to templates.
• With more than 20 devices in location or 60 on the network, some actions will take longer due to increased network traffic.
• When pushing to devices, the status may incorrectly show that the push failed. If the Sync Status changes from ‘Not Synced’ to ‘Synced’, then the push was successful.
• When deleting a virtual device, Designer will warn that encryption and password settings will be changed; however, the discovered devices’ encryption and password settings will not be affected.
• When working with virtual devices and presets, channel names do not revert to default values when “Restore Default Settings” is clicked, and location may take time to respond.
• When loading a preset on a virtual P300 device, saved Off Attenuation and EQ Contour values will be overwritten by Mic Optimization mode defaults.
• Event log may incorrectly say “Push failed” for “Push to Dante” events, though the description will say that the event was successful. In these cases, the event was successful.
• In Coverage Map, changing the unit of measurement will not be saved for the location; the unit of measurement will default to feet when the location is reopened.
• When importing a Designer preset file into the MXA910 web application, attempts to immediately export that file out of the web application will fail if it's not first loaded and saved to the MXA910.

Notes

• Internet access is required during the installation process.
• Designer User Guide
• System Requirements
• Designer 3.1 is compatible with the following firmware versions:
  • MXA310 version 3.1.5
  • MXA910 version 3.1.5
  • P300 version 3.1.5
  • ANIUSB-MATRIX version 3.1.5
• Requires 64-bit Windows 7, 8.1 or 10